Audi RS Mode Activation Rainbow Module Gen3 for all Audi A and Q models.
It will enable the engine data, G meter and rpm flashing. It is required to have Sport Layout for all of the A/Q models with minimum 0379 in the Virtual Cluster software version.
If your VC firmware is lower than 0379 please contact us, we can provide firmware update for it.
It has 3 different starting points for the rpm flashing. Wiring diagram will be shared. We provide full support for installation.
Total Reviews (0) click here write review to add review for this product.
Report this review.
Remove the rear bench from the vehicle by unclipping the isofix anchors and pulling the bench upwards.
Locate the CANBus plug in the centre module and unplug it. You can then remove the connector from the plug to access the wiring pin box.
Plug in the wires from the racebox module using the following guide. If any of the pins already have a wire in them, remove the stock wire and plug it into the racebox matching the corresponding wire colour. The wires you plug into the pin box will not necessarily match the colour of the stock wires you unplug.
The orange and green wire plugs into Pin 13
The red and blue wire plugs into Pin 18
The orange and black wire plugs into Pin 31
The brown wire plugs into Pin 54
After successfully installing the module, replace the rear bench and and reinstall the isofix anchors.
